Dascom TallyCom III Getting started with PrintGuide Manuale Utente Scaricare il pdf (Pagina 12)

Getting Started with PrintGuide

™

2 TallyCom III PrintServers

Once the hardware printer attachment has been installed according to its

”Installation & Operator’s Guide”, you should be able to discover it with

PrintGuide (In Monitor View, select Monitor, Discover).

The Hardware PrintServer appears in the Monitor View’s list of Detected

Devices with either IP address or universal MAC address (See label

attached to the bottom or rear panel of the hardware printer attachment).

The MAC address looks like this: 00036e00483a.

The DLC discovery protocol must be enabled, unless the PrintServer has

an IP address. Please note that the DLC protocol is not available on

Windows ME and XP. Please refer to the manual that came with your

PrintServer for more information on assigning the IP address.

Refer to “1.6 Discovery preferences” if the PrintServer remains

undetected.

2.1 Configuring the PrintServer

Now that the PrintServer is installed and discovered, only two conditions

remain to be fulfilled before the PrintServer can be used for printing:

• One or more logical printers must be enabled and configured.

(Refer to “Example of configuring a logical printer”)

• The logical printer's corresponding network protocol must be

enabled and configured (refer to 2.4, Network settings)

Table 2 shows some of the logical printers and the network protocol they

rely on.

Logical

Printer

Network

Protocol

LAN (Novell) using IPX/SPX IPX/SPX

LAN (TCP/IP) using LPD TCP/IP

LAN (TCP/IP) using Port 9100 TCP/IP

FTP Printer FTP

IPP 1.0 Printer using HTTP TCP/IP

LAN (Windows) using NetBEUI/NetBIOS NetBEUI

Table 2

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Nessun commento

Dascom TallyCom III Getting started with PrintGuide Manuale Utente Pagina 12